Canopies

The AMI Series 100 Canopy is a versatile system that can be modified for many different applications. The system is designed for versatility in size and configuration. It is available in many different finishes, from anodized to exotic kynar paints.

The system is designed on job specific bases. That is to say, the structural attachments and design are engineered specifically to field conditions and architectural design. Outrigger material, size and attachment are based on field conditions and calculated for weight and design.

Post Mortem Facility

Post Mortem Facility

Post Mortem Facility

Post Mortem Facility

Post Mortem Facility

Post Mortem Facility

The support bracket is composed of a plate welded to the structural Outrigger Beam. The unit is then welded or mechanically fastened based on field conditions. The support bracket is painted to match the grill or can be covered by other materials such as tubular aluminum, composite panel or aluminum sheet. It can also have tie rod attachment of tubular aluminum or steel.

The Canopy Grill is composed of 1 3/4” x 4” fins with a 2” x 8” face member. The grill members shall be extruded architectural aluminum 6063-T5 alloy and tempered. Major portions of the grill sections shall be a nominal .125 inches. Screws, nuts, washers, bolts, rivets, and other fastening devices shall be aluminum, stainless steel or other non-corrosive materials. (Note that the fins and face can be modified for specific conditions.)

All tubular aluminum extrusions will be joined together at corners by heavy concealed brackets. The brackets shall be secured with screws. These screws shall be counter sunk and painted to match the extrusions.

The tubular extrusions are covered with flat sheet aluminum decking, aluminum composite panels or roofing material (depending on architectural design and building requirements and are flashed to the building.

The Canopy assembly shall be attached to the support bracket by heavy brackets and shall be secured with screws.

After installation the Canopy shall required adequate protection of exposed finishes from damage by grinding and polishing compounds, plaster, lime, acid, cement or other contaminants.

Please see engineer’s notes and calculations for the design wind, dead, live and snow loads for any specific project.